X-BEAM 300

Key Features of X-BEAM 300 

•  ON-OFF Push Switches.

• Major & Minor Power Line Compensation.

• Radiographic KVP Selection from 40 KVP to 100 KVP in steps of 2 KVP.

• Technic Selector – To select 50mA, 100mA, 200mA & 300mA.

• Fluoro, Radiography, Bucky Radiography, Accs selection.

• Fluoro timer reset.

• Preparation & Exposure Push Switches.

• LED indication for Line on, X-Ray on & Tube overload.

• Power Line Compensation Indication.

• mA indication for Radiography & Fluoroscopy.

• Solid State Electronic Timer in 24 steps from shortest exposure time of 0.02 sec and Maximum 5 sec.

• Spot Film facility at all mA Technics.

• The system will trip off in case of overload in H.T. or L.T. Circuit.

• There will be no exposure if the selection of exposure factor exceeds Tube Ratings.

• X-Ray initiation by means of Hand Switch or from Control.

• Fluoroscopic Timer.

 Technical Specification :

•  Full wave Rectified Two Pulse X-Ray Generator.

• Output – 300mA at 100KVP

• Radiographic Voltage – 40 KVP to 100 KVP in steps.

• Fluoroscopic Voltage – 50 KVP to 100 KVP in steps.

• Fluoroscopic mA – 0 – 3 mA.

• X-Ray Tube – BEL DRA-1/THX-1 Rotating Anode Tube Unit or equivalent.

• Overload – Fully protected.

• Single Tube operation with provision for coupling second tube.

• Power Requirement – 400V/50Hz with line resistance .5 ohm to be connected through phase Reducing Transformer.

| Home |  Products  | Contact us |  Feedback |